PLEASE READ FULL INFO BEFORE PURCHASING

All sales are final and cancellations or returns are NOT accepted. If you purchase this service, it is a reservation in a queue and CANNOT be refunded. IF YOU CANCEL AFTER PURCHASING YOU WILL NOT RECEIVE A REFUND.

This listing is to purchase the service of a design (if applicable) and installation of our floating conversion kit to a set of center caps you will send to us. Do NOT purchase without first contacting us to confirm this conversion can be done for your center caps. Customer is responsible for shipping the center caps to our location. Once purchased, we will contact you and provide a shipping address to send us your center caps. All in house conversions take approximately 2 weeks to complete upon receiving your center caps. Unexpected delays by shipping carrier are out of our control, and custom designs can expect a possible slight delay for completion.

Key reminders!  
- These will convert your caps to spin. In order for there to be enough clearance, there is the possibility you may need to lightly sand down the inside bore of your center cap opening of the wheel face. This may be common on chrome plated or freshly powdercoated faces. Some center caps may be tight when normally mounted, which in order to spin freely will need the clearance around the cap. 

- There is approximately 15mm of components behind the center cap. You may need to measure to ensure your axle/axle nut will not interfere with the components causing the cap to be stuck. 

- This kit may slightly protrude the center cap emblem original location due to the required clearance behind the emblem to spin. 

These kits are 3D printed with ABS filament and use ball bearings for the spinning components. Never use a screwdriver or attempt to disassemble the components as it will damage and break the small parts.