PLEASE READ THE FULL DESCRIPTION BEFORE PURCHASING!
All sales are final and cancellations or returns are not accepted for any Floating Cap DIY kits. Ships approximately 7-10 business days (2 weeks) after order is placed.
TE37 wheels are commonly a low disk mount which causes the vehicles axle end/axle nut to protrude the center bore of the wheel or sit close to flush. You MUST measure the center cap bore opening on the face to ensure the correct size kit. There are many different variables to ensure our center cap floating kit will work with your setup; disk size, hub depth, spacers, axle nuts, axles, etc. If you are unsure if there is enough clearance behind the cap to choose from raised or flat housing, we HIGHLY encourage to first purchase our TE37 test kit to see which of the two options (flat or raised) will work best with your setup. We will reimburse you a $5 refund from the purchase of a single test kit (not including shipping) after you purchase the floating conversion kit.
Enhance your Volk TE37 wheels with this floating center cap conversion kit. These will spin your center caps effortlessly, will remain level while parked and have a slight “floating” feature while driving, enhancing the overall appearance of your wheels.
This DIY kit does not include any emblems. Please note that you need to purchase a set of 50mm center cap gel stickers to transfer onto the new floating cap assemblies. These have been designed specifically for the Sensei 6 "Volk" gel cap overlays that you can purchase directly from Sensei 6 here. Or you can have a custom 50mm gel sticker made by another third party company. We also offer a custom logo option if chosen that will be a 60mm diameter center cap that is 3D printed.
This kit is an o-ring press fit style.
Flat - Your axle end/axle nut must sit at least 10mm inside the hub from edge of center cap bore lip at the face. For more clearance, it may be required to run a small wheel spacer.
Raised - Your axle end/axle nut must not protrude more than 5mm poking out from edge of center cap bore lip at the face. For more clearance, it may be required to run a small wheel spacer.
Paper Instructions are included.
Kit includes the following -
4x floating cap assemblies
4x Rubber O-rings
Key reminders!
- There is approximately 15mm of components behind the center cap. You may need to measure to ensure your axle/axle nut will not interfere with the components causing the cap to be stuck.
These kits are 3D printed with ABS filament and use ball bearings for the spinning components. Never use a screwdriver or attempt to disassemble the components as it will damage and break the small parts.
